Not signed in (Sign In)

Vanilla 1.0.1 is a product of Lussumo. More Information: Documentation, Community Support.

    • CommentAuthorfangsihan
    • CommentTimeDec 15th 2017
    A Drop-In anchor consists of a tubular expansion shield and a solid, cone-shaped expander plug. The expander plug is case hardened and tempered to prevent galling and binding during expansion. The shield has four equally spaced slots for a portion of its length, the bottom part may be knurled. The shield also has a smooth, flangeless top that allows either flush or countersunk installation. the bottom lip of the shield is tapered to allow maximum depth and holding power.


    Anchor Size/Hole DiameterTMinimumUltimate Tensile (lbs.)Ultimate Shear (lbs.)

    Bolt SizeThread LengthEmbedment4000 psi. Concrete



    1/25/83/4-1 3/162

    5/87/81-1 3/1621/257508754

    3/411 3/16-1 1/433/161080711627

    A two-piece, internally threaded expansion anchor with four equally-spaced longitudinal slots extending from the

    bottom end of the outer

    Descriptionshield, inside of which sits a pre-assembled dilating plug. The bottom lip of the anchor is tapered. It is permissible

    for a section of the

    shield to be knurled, to increase the gripping action of the anchor.

    Intended for flush mounted, medium to heavy-duty applications in solid materials such as stone and concrete. It

    Applications/can be used in, but are

    not limited to, overhead assemblies such as duct work and pipe hangers because the internal plug holds its


    position. Can also be used

    to anchor handrails and floor-mounted door stops.

    Steel18-8 Stainless

    MaterialAnchor body: AISI 12L14 cold rolled steel

    Expander Plug: AISI 12L14/1215 cold rolled steel,Anchor body: 303 Stainless steel

    case-hardenedExpander Plug: 303 Stainless steel

    and tempered

    Anchor SpacingAnchors should be installed a minimum of ten anchor diameters between each other and a minimum of five anchor

    diameters from the edge.

    Depth of HoleShould be at least equal to the length of the anchor.

    Tensile andThe suggested safe working load is one-fourth the average proof test loads shown in the above table.


    Strengthsanchors products